=
Search
1
General information
2
Technical information
3
Safety information
4
Storage information
5
Information regarding discharge of liquids
6
Information for replacing the functional units
7
Information for disassembly
8
Information about overhauling
9
Assembly information
10
Fluids filling information
11
Information about optional components
12
Information on adjustments
13
Tools information
14
Information about failures
15
Glossary
Engine starting after storage
- Remove the protective sheet.
- Use a cloth soaked in degreasing product to remove the protective treatment from the external parts.
- Inject lubricating oil (no more than 2 cm3) into the intake ducts.
- Adjust the alternator belt tension (Par. 6.4.2 from points 2 to 4) or replace if there are signs of deterioration.
- Refill the tank with fresh fuel.
Warning
-
Over time, lubricants and filters lose their properties, so it is important to consider whether they need replacing, also based on the criteria described in Tab. 2.8 - 2.9.
- Make sure that the oil and the coolant are up to the maximum level.
- Start the engine and run it at idle speed for around 2 minutes.
- Bring the engine to 75% of maximum rated speed for 5 to 10 minutes.
- Stop the engine and while the oil still hot, perform the operation in Par. 5.2 - 5.3.
- Replace the filters (air, oil, fuel) with original spare parts.
- Perform the operations described in Par. 10.1 - 10.3.
Loading